ARP 104-6006 Porsche 914 – 912E – VW Type 4 1.7 – 1.8 – 2.0 Rod Bolt Kit

Connecting Rod Bolts, High Performance Series, 8740 Chromoly Steel, fits VW Type 4, Porsche 914, and 912E, 1.7, 2.0L, Set of 12.

Application: PORSCHE 1. 7L & 2.0L TYPE IV
Press Fit – Rod Bolt Installation

(1] Please check the part-number(s) for your application
against the part-number(s) listed on the instruction sheet.
[2] Make sure there is an adequate chamfer around the top
of the connecting rod bolt hole to clear the radius under
the head of the bolt.
[3] Press the bolts into the connecting rods and install the
rod caps.
(4] Use ARP Ultra-Torque Fastener Assembly Lubricant
to lubricate the threads of the bolt and the nut face. Then
install the nuts onto the bolts and tighten them hand tight.
[5] ARP recommends using the STRETCH METHOD when
tightening the bolts. Following the instructions for using a
stretch gauge, Stretch the bolts to . 0055 – . 0060 .
[6] If you do not have a stretch gauge, torque the bolts to
40 ft-lbs using ARP Ultra-Torque Fastener
Assembly Lubricant.
[7] The connecting rods should always be re-sized after new
rod bolts are installed.
[8] A log should be kept on the original non-torqued length of
each bolt. Bolts that have any permanent deformation or
have increased in non-torqued length by more than .001
in. should be replaced.